Drawing of the motor is HERE.
3D model (3/8" shaft version) is HERE.
3D model (10mm 2 flats shaft version) is HERE.
This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with a PWM (Pulse Width Modulating) controller. The gear motor is measured to be 7 inch long and the motor itself has a diameter of 2.5 inches. Drive shaft is 10mm in diameter with 2 flats where flat to flat is 6mm. The shaft has a threaded end that is to fit a M6 tightening nut. Rated voltage of this gear motor is 13.5 VDC and maximum speed is 50 RPM. Rated output load is 60 watts and output toruqe at 50 RPM is 6 N-m (4.4 ft-lb). Mounting is based on M6 screw mounting. The 12V DC PWM controller features a 5 inches(12.7 cm) long connection to its potentiometer. The potentiometer has a on/off switch built-in with a knob. An overload protection is set at 10 amps of current so the controller will shut down when such a current occurs. There are connectors between the gear motor and the controller. To run the gear motor in CW rotation, please connect motor's green connector to controller's red connector and motor's red connector to controller's black connector. To run the gear motor in CCW rotation, please connect motor's green connector to controller's black connector and motor's red connector to controller's red connector. The distance of the connection wires between the motor and the controller is 10 inches(25.4 cm). The distance of the 12v connection wire is 46 in(116.8 cm) long.
4 Reviews Hide Reviews Show Reviews
I've been looking high and low for a motor like this. It fits my application perfectly!
The products I bought all work great, the service I received on the phone was 5 star . Thanks again.
I was looking for a modest cost DC motor to control two pumps. This worked great. Really only got reliable rpm down to about 20-25 rpm. Great torque for the price.
Had a little issue with variable speed not working. Once it started, it is working well now